FPM Agromehanika 627 678, Сборка / Эксплуатация / Техническое обслуживание, Список запасных частей

Страница: 29 / 62

ADJUSTMENTS AND MAINTENANCE
FPM Boljevac
V-BELTS
The V-belts must be properly tensioned in order to
prevent excess sliding. Insufficiently tensioned V-belts
will cause poor performance of the cutting unit, as well
as premature damage and tears (see Section 2 on page
15).
To tension the belt, loosen two nuts (A; Fig. 52). Keep
tightening the nut (B) until a 9 daN force is achieved, i.e.
10 mm sag between the belts. In doing so, make sure
that the housing is sitting properly on the frame. Finally,
retighten the nuts (A).
WARNING: IT IS IMPORTANT TO CHECK THE
TENSION OF THE BELTS AND TO PROPERLY
TENSION
THEM. IN PARTICULAR, THESE
OPERATIONS MUST BE PERFORMED 30 MINUTES
AFTER COMMISSIONING.
WHEN REPLACING WORN BELTS, REPLACE THE
ENTIRE BELT SET, REGARDLESS OF THE
INDIVIDUAL BELTS’ CONDITION.
C A U T I O N: CHECK THE TENSION OF
ALL SCREWS AND NUTS
REGULARLY,
IN
PARTICULAR IN THE
CUTTING UNIT AREA
WHERE DISCS AND
CUTTERS ARE LOCATED.
C A U T I O N
1. IT IS YOUR RESPONSIBILITY TO PROTECT YOUR MOWER. REPLACE ALL WORN
OR DAMAGED PARTS WITH ORIGNAL PARTS FROM IMT AGROMEHANIKA AD
BOLJEVAC IMMEDIATELY.
2. LUBRICATING, ADJUSTING, CLEANING AND CONFIGURING OPERATIONS MAY
ONLY BE PERFORMED WHEN THE TRACTOR AND THE PTO SHAFT ARE
SWITCHED OFF.
3. WAIT UNTIL ALL MOVING PARTS HAVE COME TO A STOP TO PROCEED WITH
MAINTENANCE.
4. KEEP YOUR HANDS, FEET, AND CLOTHING AWAY FROM THE MOWER’S MOVING
PARTS.
5. ALWAYS KEEP THE CONSEQUENCES OF IRRESPONSIBLE AND UNSAFE WORK IN
MIND, SINCE THIS MAY CAUSE GRAVE HARM.
6. BEFORE TURNING THE TRACTOR ON AND COMMENCING WORK, ENSURE THAT
NO INDIVIDUALS OR ANIMALS ARE IN THE MOWER WORK AREA.
CAUTION: STOP AND THINK! ROTATING PARTS MAY CAUSE SERIOUS BODILY
HARM.
Page 29