FPM Agromehanika 627 678, Сборка / Эксплуатация / Техническое обслуживание, Список запасных частей

Страница: 27 / 62

LUBRICATION
FPM Boljevac
WARNING: IT IS RECOMMENDED TO REDUCE THE QUANTITY OF OIL IN THE CUTTING
UNIT DRAWING A POSITIVE OR NEGATIVE ANGLE DURING OPERATION WITH THE
HORIZONTAL LINE BY ABOUT 25 PER CENT.
IT IS ALSO RECOMMENDED TO HOLD THE CUTTING UNIT HORIZONTALLY FOR A FEW
MINUTES EVERY HALF AN HOUR.
LUBRICATION
Inspect the lubrication condition of all places
with installed grease nipples and other glide
surfaces.
Good lubrication level should be achieved every
eight hours of operation. Prior to lubrication, remove
dirt and dust from the surfaces. Lubricate rotating
and articulated parts every fifty hours. Lubricate all
telescoping parts as needed.
1. Front joint grease nipple.
- every 8 hours
2. Rotating guard part on the front PTO shaft
end.
- every 40 hours
3. Inner telescopic tube part.
- every 20 hours
4. Rotating guard part on the rear PTO shaft
end.
- every 40 hours
5. Rear joint grease nipple.
- every 8 hours
6. Locking bolt on the front and rear end.
- every 40 hours
7. Clean all shaft parts if the shaft was out of
use for a prolonged period of time.
Figure 23.
By following this lubrication chart, you will achieve longer service life of the shaft. Careful
maintenance prevents malfunctions resulting from heating or damage of the bearings, or increased
axial force. Lubricate the PTO shaft on indicated places using high-quality lubricating grease.
GREASE ALL ROTATING, SLIDING, AND ARTICULATED JOINTS ON THE MOWER FRAME.
NOTICE: ALWAYS KEEP IN MIND TO USE THE GREASE WITH REQUIRED QUALITY IN
ORDER TO PREVENT UNINTENTIONAL DAMAGES TO THE MACHINE. BY PROPER AND
REGULAR LUBRICATION, UNINTERRUPTED AND SAFE MOWER OPERATION IS ENSURED.
Page 27