FPI P36-LP3, Инструкция для владельца и по установке

Страница: 36 / 76

FPI P36-3 Zero Clearance Direct Vent Gas Fireplace
36
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit (Part # 512-930) contains the
following pieces:
a) 02-49 Rear Log
b) 02-55 Middle Left Log
c ) 02-50 Front Left Log
d) 02-53 Center Left Log
e) 02-51 Front Bottom Log
f ) 02-54 Center Right Log
g) 02-52 Middle Right Log
h) Embers
i) Vermiculite
NOTE: If you will be installing the optional
Brick Panels, install the Brick Pan-
els prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite around the firebox
base.
Vermiculite
Vermiculite Vermiculite
The "02" refer numbers (i.e. 02-49) are
molded into the rear of each log.
OPTIONAL
BRICK PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2) Insert the back brick panel first by carefully
slipping it between the back wall of the
firebox and the rear log bracket.
3) Put the side panels in next. Slide them in
from the front and push them flat up against
the wall. Be very careful not to scratch
them on the firebox hardware.
4) Install the 2 brick retaining clips, one on
each side.
3) Place the Log 02-49 on the rear log support
pins with the flat side to the back.
14) Replace yellow "Natural Gas" label with red
"Propane" label
15) Check for gas leaks.
16) Check inlet and outlet pressures.
17) Check operation of flame control.
18) Check for proper flame appearance and
glow on logs.
INSTALLATION