FPG IN-5C08-OF, Руководство по эксплуатации продукта

Страница: 11 / 44

IN-5C08/12-OF
- 11 - © Future Products Group
Preparation
cont.
REFRIGERATED CABINETS - OPERATION
Shelf
Adjustment To move the shelf support brackets, remove the rear sliding doors and then
remove all the shelves. Using two people, one on each bracket, slide the
bracket upwards and disengage it from the support pillar. Insert the bracket in
the new position and push it down
firmly. Replace all shelf trays and
doors.
The brackets can be inserted in two
positions, allowing the shelves to be
either horizontal or sloping
downwards.
Caution Make sure the shelf brackets are pushed down as far as they can go.
Otherwise, the shelf may collapse, when loaded with product.
Power Supply Ensure that power is connected to the cabinet.
Turn on the main power switch, as shown above. The cabinet fans will run
and the cabinet temperature will begin to fall.
The temperature controller is pre-set to maintain the cabinet temperature to 2

-
4

C, and should not need adjustment.
Defrost Cycle Note that the defrost times are set from when the cabinet is first turned on.
If they are required at a particular time, you must turn on the cabinet 2 hours
before the first defrost required. The time depends on the cabinet type, see
Controller Settings.
The cycles will then occur every 2 hours, provided that the cabinet remains on.
Load Cabinet
Load the cabinet with pre-chilled product, from either the front or rear doors.
The cabinet is designed to maintain the temperature of pre-chilled product at
between 2

and 4

C. It is not a refrigerator, and consequently, if warm
product is introduced, there could be some delay before the operating
temperature falls to the normal operating level.
Continued on next page