E
VO
C
LAS
SIC
X
GB
E
VO
C
LAS
SIC
X
GB
NOTE: Like all materials, the cover to the Evolution Classic X may be affected by hot or wet weather.
This may cause the cover to go slack in wet conditions or tighten during warm weather. To allow you
additional flexibility, you will see that above each moulded foot there is an elastic loop fitted to the cover.
These may be hooked over the claws on each moulded pivot which will take up any slack in the cover.
TIP: In windy conditions, you will find it easier to loosely peg your Evolution Classic X down with one of
the rear peg down points and erect it ‘side into the wind’.
7. Repeat the process for the
remaining front pole
8. The Evo is now fully erected - peg down the two rear pegging
points. A unique feature of the Evo is that it can be set at a range of
different heights and widths. To alter the size and shape simply
move the two side poles outwards to lower and increase coverage
in bad weather, or move them inwards to increase the height and
narrow the shelter to fit tight swims
9. To dismantle the Evo, unhook the tension elastics if they have been
used, and remove all pegs. Standing at the front of the Evo place a
hand on top of the boss and apply gentle downward pressure, tilting
the boss towards you. At the same time lift the front pole slightly
upwards and slide out. Repeat for the other front pole
10. Disconnect the rear poles
11. Remove the short centre pole. This should be done by lightly
pressing down on boss and centre pole to decrease the tension.
As the centre pole straightens it is simply disconnected from the two
bosses. Store the pole inside one of the front mesh tunnels
12. Gather all of the poles together and roll the Evo up, storing it in the supplied sleeve
EVOLUTION CLASSIC X 17/5/06 4:22 pm Page 6
