Four winns Horizon 210, Руководство пользователя

Страница: 109 / 159

Section O
Page 2
Horizon & Sundowner
Owner’s Manual
06/00
3. Adjust the secondary bow to support the canvas and
attach the nylon strap to the strap eye located on
the deck. The strap can be adjusted for tautness.
NOTICE
On the Horizon and Sundowner models, cou-
plers on the bow extensions allow for vertical
adjustment. Horizontal adjustments can be
made with the buckle located on the nylon strap
and by sliding the secondary bow(s) up or down
along the main bow.
B. Side Curtains
The side curtains are used to enclose the area between
the windshield wings and canvas. Each curtain will zip
to the underside of the suntop and snap to the wind-
shield wings. Windshield snaps will slide to adjust to the
curtain.
NOTICE
DO NOT FOLD THE SIDE CURTAINS! Dam-
age may result. Always roll the side curtains up
to prevent damage to the isinglass.
C. Aft Curtain
The aft curtain encloses the remaining cockpit area when
the suntop is installed. The aft curtain is part of the full
canvas option (which includes suntop and side curtains).
Refer to Figure O1.
Figure O1: Full Canvas
To install:
1. Attach the aft curtain to the zipper provided on the
rear portion of the suntop.
2. Secure the rear corners.
a. If the canvas has snaps along the aft edge, se-
cure the corners.
b. If the canvas has shock cords along the aft edge,
attach to knobs as shown in Figure O2.
Figure O2: Shock Cords
3. Finish snapping canvas to deck.
When storing the aft curtain, roll the canvas which will
keep the isinglass from creasing.
D. Forward Cover
The forward cover is available on Horizon models. It is
installed over the bow seating area and is snapped to
the deck. An adjustable pole is provided to adjust the
canvas for tautness and prevent the build up of water.
Refer to Figure O1.
E. Bimini Top (Bimini/Camper)
A bimini top is available on the Horizon and Sundowner
models. The new style bimini top has been extended
so the top can be incorporated into a camper top con-
figuration. The bimini top is a freestanding top and sup-
ported only by the bow assembly. If desired the bimini
top can be booted as shown in Figure O3.
To install:
1. Attach the main (primary) bow to the windshield
mount.
2. Attach the secondary bows (aft of the main bows)
to the deck mount. Note: The support bows should
be loose to allow for adjustment.