Four winns Horizon 210, Руководство пользователя

Страница: 51 / 159

Section E
Page 3
Horizon & Sundowner
Owner’s Manual
06/00
3
0
TO
5
0
be found in the engine operator’s manual included in
the owner’s packet.
Figure E2: Running Angle
B. Power Tilt
Power tilt allows the operator to raise and lower the drive
or outboard motor for trailering, launching, and beach-
ing. Additional information on power tilt can be found in
the engine operator’s manual included in the owner’s
packet.
NOTICE
DO NOT operate the motor with the water in-
takes out of the water. Severe damage to the
engine systems can result. Consult the engine
operator’s manual for specific information.
E - 6 TRIM TABS
Electric/hydraulic trim tabs are standard on the 280 Ho-
rizon and 285 Sundowner models. They are optional
on the 230 and 260 Horizon and 235 and 265
Sundowner models. Trim tabs help provide maximum
control of the hull in all water and load conditions. If
used properly, trim tabs can
a. Compensate for wind and load listing (level the boat
side to side).
b. Induce faster planing and help achieve optimum run-
ning angle (see Section E-5 Running Angle & Power
Trim/Tilt)
Changing either diameter or pitch will have an effect
on engine speed and prop slip, and in turn, directly
affect the performance of a boat. The propeller(s) in-
cluded with each Four Winns® boat provide the best
general performance based on data obtained from
on-the-water testing of that model. Variations in load,
operating conditions, environment, the individual en-
gine and hull performance may necessitate the pur-
chase and use of another propeller(s).
Under your normal load conditions the engine(s) should
turn within the maximum RPM range when at full
throttle. If the engine(s) exceeds the recommended
RPM, an increase in pitch and/or diameter is required.
If the engine RPM is too low, a decrease in pitch and/
or diameter is required.
An engine that is not developing full power and the
load carried in a boat will directly affect performance of
the engine. Always be sure the engine is properly tuned
and load conditions are those normally experienced,
before changing propellers.
For additional information on factors affecting perfor-
mance, please consult your Four Winns® dealer.
E - 5 RUNNING ANGLE & POWER
TRIM/TILT
Hull planing surfaces have the least amount of drag at
a three to five degree angle with the water. This is the
preferred running angle when boating. The running
angle has a significant impact on top speed and han-
dling. See Figure E2. Heavy load or certain water
conditions may make it difficult to achieve the optimum
running angle. The running angle can be controlled
through the use of the power trim.
A. Power Trim
Trim angle is how far in or out, the drive or outboard
motor is positioned in relation to the bottom of the boat.
The trim angle of the drive or outboard engine has a
distinct affect on the running angle of the boat.
The power trim system permits control of the trim angle
of the drive or outboard motor relative to the boat, at
the touch of a button. It allows the drive or outboard
motor to be raised for shallow water operation. Power
trim also allows the operator to adjust the motor while
underway to provide the ideal running angle for a given
load and water condition. Additional information can
Boat Properly Trimmed
Boat Too High - Trim Bow “Down”
Boat Too Low - Trim Bow “Up”