FOUR WINDS INTERNATIONAL
NOTE:
Only use this procedure when the room will not retract with the room control switch
The room can be retracted manually if an electrical failure prevents the room from being retracted
using the ROOM CONTROL SWITCH. For normal retract sequence see the ROOM RETRACT
PROCEDURE.
1. Make sure coach disconnect is off and clear any obstruction in the slide out area.
2. Locate the electric motor and gear drive assembly. This may be under a couch, bed, etc.
You may also have to remove an access panel if applicable.
3. Depending on the slide mechanism, either a 9/16” or 5/8” wrench will be needed. Rotate
the manual override shaft enough to see if it will need to be rotated clockwise or
counterclockwise to retract the slide room.
4. Rotate the shaft until the room is retracted fully.
5. The system should be repaired before using again.
Interior Controls & Operations
4-13
Non-Hydraulic Slideout - Manual Room Retraction Procedure
Содержание Chateau
