Before installing the Koliber rotating head, a leveling wire must be mounted (Fig. 11
and 12).
The element that joins the jib and the head should – independent of the tilt angle of the
jib – remain in the horizontal position. The tilt is regulated by a Roman screw placed on
the leveling wire.
The operating part of the jib may be shortened by half. In order to do so, slide back the
telescopic elements of the jib and place the end of the wire on the wheel (Fig. 11), where
the “end-eye” of the wire had been installed earlier. In this version, the flexing wire is not
used.
Mounting the Koliber head
In order to mount the head on the camera crane securely and properly, slide it
simultaneously into the two quick connector sockets. Next, secure the head by tightening
the blocking knobs on the side. Further steps of installing the registering device are set
forth in a separate manual for the Koliber head.
9
Fig. 11
Fig. 12
Fig. 13
Fig. 14
