Additional Jib function
The jib function is a configuration of the crane where the operator is directly by the
camera mounted at the end of the jib. The arm should be extended to the half of its
length in this configuration.
In order to do so, install the Jib adapter (included in the set – Fig. 15) to the end of the
jib. Tighten a standard oil head to the adapter (Fig. 16). After balancing the set
(remember about the safe order of actions), the operator receives a device which joins the
advantages of a crane and a stabilizer. This allows for exceptionally smooth and dynamic
shots and rests the operator from the weight of the equipment.
After mounting the recording device unblock the tilt brakes of the jib slowly and check
whether the crane is balanced appropriately. For precise regulation of the balance use the
additional weights mounted along the counterweight arm axis (Fig. 17).
If the mass of the counterweight is inappropriate, add or remove weights on the neck in
order to achieve the required balance.
The set includes a universal grip for the monitor and/or head controller (Fig. 18). When
installed at the center of the jib, it keeps the proper position independent of the arm tilt.
10
Fig. 15
Fig. 16
Fig. 17
Fig. 18
