Assign IP Address
Assign IP Address
The initial Basic Network screen displays the Product Descriptor and the type of system you are
configuring. See
Naming Conventions on page 1
.
1.
Configure the FortiNac appliance and enter the values based on the definitions in
Basic
Network Window Field Definitions below
.
WARNING:
Do not use the following as the Host Name for the appliance: nac,
isolation, registration, remediation, remotereg, remotescan, vpn, authentication, hub,
access point management, or deadend. These names are reserved for system use.
WARNING:
Host names should contain only letters, numbers or hyphens (-).
Uppercase letters are converted to lowercase automatically.
2.
Click
Apply
.
3.
Review the information in the Results page. If there are errors or omissions, click Back
on the browser. Make the changes and reapply them.
4.
Reboot or shut down the appliance. The DHCP service accessed via eth1 during
installation is disabled.
Note:
The data displayed in the Configuration Wizard may not represent the current
configuration of the appliance. When you make edits in the Configuration Wizard, your
modifications are stored in a temporary file. This allows you to exit the Configuration
Wizard before you save your changes permanently.
Table 9: Basic Network Window Field Definitions
Field
Definition
FortiNac Product
Host Name
Name of the appliance you are configuring. Host names should contain only
letters, numbers or hyphens (-). Uppercase letters are converted to lowercase
automatically.
Note:
Do not use nac, isolation, registration, remediation,
remotereg, remotescan, vpn, authentication, hub, or deadend.
These names are reserved for system use.
eth0 IP Address
Management IPv4 address of the appliance you are configuring.
Default Gateway
Default Gateway IPv4 address for the appliance you are configuring. A
default gateway is the device that passes traffic from the local subnet to
devices on other subnets.
eth0 IPv6 Address
Management of IPv6 address of the appliance you are configuring.
IPv6 Default Gateway
Default Gateway IPv6 address for the appliance you are configuring. A
default gateway is the device that passes traffic from the local subnet to
devices on other subnets.
10
Содержание FortiNac BFN320
