Fortinet FortiManager-1000C, Руководство по установке стоек и оборудования

Страница: 26 / 32

Installing Hard Drives
FortiManager-1000C™ Version 4.0 Rack and Hardware Install Guide
24 02-40000-112634-20091026
http://docs.fortinet.com/ • Feedback
1 If present, remove the front bezel. See “Installing the Bezel” on page 19 .
2 From the RAID management software, prepare the drive for removal. Wait until the
hard-drive indicators on the drive carrier signal that the drive can be removed safely.
See your storage controller documentation for information about hot-swap drive
removal.
If the drive has been online, the green activity/fault indicator will flash as the drive is
powered down. When the drive indicators are off, the drive is ready for removal.
3 Press the button on the front of the drive carrier and open the drive carrier release
handle to release the drive. See
Figure 2 .
Figure 2: Installing a Hot-Swap Hard Drive
4 Slide the hard drive out of the drive bay.
5 Insert a drive blank in the vacated drive bay. See “Installing a Hard-Drive Blank” .
6 If applicable, install the bezel. See “Installing the Bezel” on page 19 .
Installing a Hot-Swap Hard Drive
1 If present, remove the front bezel. See “Installing the Bezel” on page 19 .
2 If a drive blank is present in the bay, remove it. See “Removing a Hard-Drive Blank” .
3 Install the hot-swap hard drive.
• Press the button on the front of the drive carrier and open the handle.
• Insert the hard-drive carrier into the drive bay until the carrier contacts the
backplane.
• Close the handle to lock the drive in place.
4 If applicable, install the bezel. See “Installing the Bezel” on page 19 .
1 release button 2 hard drive carrier handle
2
1
Caution: When installing a hard drive, ensure that the adjacent drives are fully installed.
Inserting a hard-drive carrier and attempting to lock its handle next to a partially installed
carrier can damage the partially installed carrier's shield spring and make it unusable.