Fortinet FIM-7904E, Руководство пользователя

Страница: 19 / 27

Hardware installation Troubleshooting
FIM-7904E does not startup
Positioning of FIM-7904E mounting components and a few other causes may prevent a FIM-7904E from starting
up correctly.
Latches and handles not fully closed
If the latches or handles are damaged or positioned incorrectly the FIM-7904E may not start up. Make sure the
latches are fully closed and the handles are correctly aligned, fully inserted and locked and the retention screws
are tightened.
Firmware problem
If the FIM-7904E is receiving power and the latches are handles are fully closed, and you have restarted the
chassis and the FIM-7904E still does not start up, the problem could be with FortiOS. Connect to the FIM-7904E
console and try cycling the power to the board. If the BIOS starts up, interrupt the BIOS startup and install a new
firmware image.
If this does not solve the problem, contact Fortinet Technical Support.
FIM-7904E status LED is flashing during system operation
Normally, the FIM-7904E Status LED is off when the FIM-7904E is operating normally. If this LED starts flashing
while the module is operating, a fault condition may exist. At the same time the FIM-7904E may stop processing
traffic.
To resolve the problem you can try removing and reinserting the FIM-7904E in the chassis slot. Reloading the
firmware may also help.
If this does not solve the problem there may have been a hardware failure or other problem. Contact Fortinet
Technical Support for assistance.
FIM-7904E Interface Module Guide
Fortinet Technologies Inc. 19