Fortinet FIM-7904E, Руководство пользователя

Страница: 11 / 27

Hardware installation FIM-7904E mounting components
3. Hold the sides of the transceiver and slide it into the cage socket until it clicks into place.
FIM-7904E mounting components
To install a FIM-7904E you slide the module into a hub/switch slot in the front of an FortiGate-7000 series chassis
(either slot 1 or 2) and then use the mounting components to lock the module into place in the slot. When locked
into place and positioned correctly the module front panel is flush with the chassis front panel. The module is also
connected to the chassis backplane.
To position the module correctly you must use the mounting components shown below for the right of the FIM-
7904E front panel. The mounting components on the left of the front panel are the same but reversed. The FIM-
7904E mounting components align the module in the chassis slot and are used to insert and eject the module
from the slot.
On some FIM modules there may be very little clearance between the front panel
interfaces and the handle on the right side of the FIM-7904E. In fact you may have to
remove network connectors from some front panel interfaces to open the handle. In
most cases you should remove all network connectors from the front panel before
opening the handles to remove a FIM module from a chassis slot.
Closed
Retention Screw
Handle
Latch
Latch
Alignment Pin
Handle
Retention Screw
Alignment Pin
Open
(when open the latch slides up about 2 mm)
The FIM-7904E handles align the module in the chassis slot and are used to insert and eject the module from the
slot. The latches activate micro switches that turn on or turn off power to the module. When both latches are
raised the module cannot receive power. When the latches are fully closed if the module is fully inserted into a
chassis slot the module can receive power.
FIM-7904E Interface Module Guide
Fortinet Technologies Inc. 11