Fortinet FIM-7904E, Руководство пользователя

Страница: 12 / 27

Inserting a FIM-7904E module into a chassis Hardware installation
Inserting a FIM-7904E module into a chassis
This section describes how to install an FIM-7904E module into a FortiGate-7000 series chassis hub/switch slot
(slot 1 or 2).
You must carefully slide the module all the way into the chassis slot, close the handles
to seat the module into the slot, and tighten the retention screws to make sure the
module is fully engaged with the backplane and secured. You must also make sure
that the sliding latches are fully closed by gently pushing them down. The handles
must be closed, the retention screws tightened and the latches fully closed for the
module to get power and start up. If the module is not receiving power all LEDs remain
off.
FIM-7904Es are hot swappable. The procedure for inserting a FIM-7904E into a chassis slot is the same whether
or not the chassis is powered on.
To insert a FIM-7904E into a chassis slot
Do not carry the FIM-7904E by holding the handles or retention screws. When
inserting or removing the FIM-7904E from a chassis slot, handle the module by the
front panel. The handles are not designed for carrying the board. If the handles
become bent or damaged the FIM-7904E may not align correctly in the chassis slot.
To complete this procedure, you need:
l
A FIM-7904E
l
A FortiGate-7000 chassis with an empty hub/switch slot
l
An electrostatic discharge (ESD) preventive wrist strap with connection cord
FIM-7904Es must be protected from static discharge and physical shock. Only handle
or work with FIM-7904Es at a static-free workstation. Always wear a grounded
electrostatic discharge (ESD) preventive wrist strap when handling FIM-7904Es.
Attach the ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame. (An ESD wrist strap is not visible in the photographs
below because they were taken in an ESD safe lab environment.)
12 FIM-7904E Interface Module Guide
Fortinet Technologies Inc.