Fortex MPP1, Руководство по эксплуатации

Страница: 10 / 16

10
Stick feeder
The IC stick feeders allow the feeding of integrated circuits of various sizes directly from the sticks.
Insertion of IC sticks:
Remove the Feeder from the assembling desk, put it
backside on a flat horizontal surface. Take out the
safety latch from one end of the stick so that the
integrated circuits do not spill out. Slide this end
under the flexible holder as far as it goes. Repeat the
procedure for the required number of positions.
Holding teeth and the safety hook are used to fix the stick feeders to the assembling desk. Press the
safety hook as far as it goes. Insert the stick feeder (along with the sticks) through the rear opening and
insert both front and rear teeth under the metal plate. Release the safety hook to fix the feeder. Make
sure it is fixed properly.
Feeding of the ICs:
Press the pinch pad of the dosing
mechanism in
the requested channel. One piece of the IC will slip
from the dosing mechanism to the picking position,
from where it can be easily picked up using a
respective needle or a suction cup.
If any of the sticks is emptied and you do not want
to remove the entire feeder, you can carefully
overfill integrated circuits from the full tube to the
empty one.