Förster-Technik TAP5-CH2-25, Оригинальная инструкция по эксплуатации

Страница: 83 / 131

Running the automatic feeder 83
•
In yesterday , you enter the minimum percentage of feed a calf must have consumed yes-
terday so that no alarm is triggered. The preset default value is 80 %. You can enter values
from 0 to 99%.
•
In Dr. speed , you enter the percentage of drinking speed that a calf must reach so that no
alarm is triggered. The preset default value is 70 %. You can enter values from 0 to 99%.
The average, specific drinking speed of a calf on the current day (today) is compared to its
average drinking speed on the last 3 days. If the entered value is not reached, an alarm is
triggered.
•
In break w.o.add. , you specify how often a calf may interrupt its feed consumption (that is,
drink less than its entitled quantity) before an alarm is triggered. The default setting is
3 breaks. You can enter values from 0 to 99.
6.6 Animal control
You can use your automatic feeder for monitoring animals.
Note: You can only obtain information about calves if you operate your automatic feeder with
animal identification.
Choose to go to the menus for animal control. The number next to the submenus shows
the number of calves recorded in the respective menu.
6.6.1 Animal list
In the Animal list, you can list your calves in a table sorted by parameters. The table is sorted
in ascending order by the first column of the first parameter. This means that the calf with the
greatest need for monitoring is at the very top of the table. The following parameters can be
displayed:
•
Feed consumption
•
Drinking speed
•
Animal visits
•
Breaks
Here is how you define which parameters are displayed in the two columns of the animal list:
1. Choose > Device data to go to the Animal list submenu.