Förster-Technik TAK5-CH2-25, Оригинальная инструкция по эксплуатации

Страница: 82 / 141

82 Running the automatic feeder
5. In Feed. day , you can check the number of days that have passed since the calf was reg-
istered.
6. In Correction , you enter the number of days by which you want to reduce or extend the
feeding duration according to the group feeding plan for the calf. The maximum possible
extension corresponds to the number of feeding days.
Note: To extend the feeding duration, use the ( +/- ) key to enter a negative number such as
-2. To shorten the feeding duration, use the ( +/- ) key to enter a positive number such as +2.
7. In Plan day , you can check the new plan day of the calf.
8. In Plan end , you can view the number of days after which the feeding plan will end.
9. In Feed , you can check the feed quantity that the calf will receive on the current day (today).
10.In Conc. , you can view the feed concentration that the calf will receive on the current day
(today).
11. In Milk ratio , you can check the milk ratio that calf will receive on the current day (today).
6.5.6 Feeding plans
The following plans are taken into account when the feed is prepared:
•
Quantity plan
•
Concentration plan
•
Quantity limitation plan
•
Milk ratio plan
When you registered your calves for the automatic feeder, you assigned them to a group (A,
B, C or D).
For each group, you can assign one of four feeding plans, for example quantity plan A for
group A or concentration plan B for group B.
If you are operating an automatic feeder with animal identification, calves from different feed-
ing groups, for example group A and group B, can be housed in the same pen or consume
feed at the same box.
Below is an example of a feeding plan.