44
Shutting down and restarting the automatic feeder
•
Perform steps 2 to 17 of the shutdown (see chapter
).
You do not have to perform step 1, cleaning.
•
Dispose of residual cleaning agent. See the cleaning agent manufacturer's technical data
sheet for more information on disposal of the cleaning agent.
Chemical burns
from cleaning agents. The cleaning agent can cause chem-
ical burns to the eyes or hands. Always wear goggles and chemical-proof protective gloves
when disposing of cleaning agents. Follow the safety instructions listed in the safety data
sheet for the cleaning agent and use the safety equipment specified.
•
Dispose of the automatic feeder as described in the Disposal chapter (see chapter
).
5.2
Restart
If you have temporarily shut down your automatic feeder for less than a year and kept it in its
location, you can reconnect it and restart it yourself. The data in the automatic feeder is usually
retained. However, if this data is lost (e.g., when the battery is depleted), contact your service
technician immediately.
If you have shut down the automatic feeder for more than a year and removed it from its loca-
tion, it may only be reconnected and restarted by a service technician.
5.2.1
Restart after temporary shutdown without change of location
In the following description, we are assuming that you have only disconnected your automatic
feeder from the water and power supply.
You can reconnect these lines yourself. To make the procedure easier and ensure that you do
not miss any steps, see the check list for restarting the automatic feeder (see chapter
Recommissioning checklist, page
) in the appendix.
Proceed as follows to restart the automatic feeder:
1. Remove the cover.
2. Clean the outside of the automatic feeder with a damp cloth.
3. Install the protective grid for the powder hopper attachment. Screw the screws back into the
holes provided. The protective grid for the powder hopper attachment prevents you from be-
ing injured by the rotating tools in the powder hopper, for example, when adding milk pow-
der.
Содержание TAK5-CH2-25
