36
1
13. Loosen locking knob G by rotating it counterclockwise.
14. Use the adjustment wheel H to set paper registration wall angle. If the sheet skews
away from the operator (L1 > L2) turn the wheel down. If the sheet skews towards the op-
erator (L1 < L2) turn the wheel up.
15. Lock the adjustment wheel by rotating knob G clockwise.
16. Set the sheets on the paper table in the corner and adjust magnetic paper guides if
necessary.
17. Run a proof sheet and inspect the output. If further adjustment is necessary, repeat
steps 13 to 16.
NOTE:
When not in use, the rotary perforation can be disengaged by sliding either the blade or
the anvil to one side so that there is at least a 5 mm (0.2”) gap between them. However,
it is recommended to remove the blades and anvils completely to avoid unwanted mark-
ing on delicate media.
For optional perforation blades see “Optional Parts” in this manual.
G
H
Содержание Atlas C350
