![background image](http://html1.mh-extra.com/html/formax/atlas-c350/atlas-c350_operators-manual_2320019080.webp)
80
3
Accuracy Checks
Alignment Calibration Check
To check that the machine has not lost its factory set alignment calibration during shipping
and/or handling carry out the following procedure:
1.
With the machine powered off open the top cover.
2.
Take a stiff sheet of paper [A] and slide it against the registration wall [B].
NOTE: Paper [A] must adhere to Paper Guidelines section of this manual.
3. Slide the sheet forwards until it comes in contact with creaser rollers. Check if both
corners [C] of the sheet enter the rollers at the same time. Make sure that during this
check the sheet remains parallel to the registration wall.
4.
If sheet [A] does not enter the rollers at the same time contact a certified service
technician.
5. Close the top cover and power on the machine.
6. Run a proof sheet with a single crease and inspect the output.
B
A
C
Continued on next page...
Содержание Atlas C350
