HD 13S14 Rev0.Dec22, 2017 Page
4
of
11
8.
One pedestal at a time, remove the protective
backing from the adhesive and install on the hood
surface.
Use caution to not contaminate the adhesive surface
Tip:
Hook the fingers on the pedestal over the hood
edge and rotate the unit into position. After
installation, remove the masking tape and “wet out”
the adhesive to the hood surface by applying
pressure with your thumb around the complete
surface of the pedestals.
Important:
“wetting out” of the pedestals will
ensure maximum adhesive bond.
9.
Start a screw into each pedestal a few turns. The tip of
the screw must not protrude into the hole where the
attachment pin will later install.
10. Peel and fold the anti-abrasion pads in half over the
hood edge between the fingers on the pedestals.
11. Push metal mounting brackets over the hood edge
aligned with the anti-abrasion pads installed previously.
Ensure each bracket is fully engaged over the hood
edge and the hole in the bracket is aligned with the hole
in the pedestal.
.
