5
EG. INSIDE CORNER
1a
1b
CONSTRUCTION
1
Start at a back corner.
See the section
layout on page 4 to confirm position.
Secure the corner as shown below.
Repeat the process for remaining panels, and
secure
panels together.
Make sure that the
bottom frame of the wall panel rests on the outer
edge of the floor.
Secure the panels into place by
screwing into
the floor.
EG. INTO FLOOR
EG. SIDES
Lay out the panels
around your base.
Position the floor
in your desired location.
We recommend starting in a back
corner then
working from the back
panel to the front panel for assembly.
FLOORS & SIDES
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW
SIDE PANEL
BACK PANEL
1c
Attach the Right Hand Triangular Pent
Section
by screwing to the back panel
and side panel as shown below.
Attach the Left Hand Triangular Pent Section
by screwing to the front panel and side panel
as shown below.
Attach the Door Battens
. Screw one batten
at the bottom into the floor bearer. Screw the
other into the Triangular Pent Section as shown
below.
SDPMRHA3
SDPMLHA3
DOOR BATTENS (28 x 28 x 590)
