6
TABLE & WINDOW ASSEMBLY
2
COVER AND DOOR STRIPS
3a
Secure the door Weather Strip
onto the side you want the hinges,
and ensure it’s flush to the floor
and against the face of the wall
panel framing.
SLAMMING STRIP(28 x 12 x 1637)
Attach the Cover Strips
to the
corners. Ensure they are flush to
the bottom edge of the panels
as shown below.
Attach the Cover Strips
on the
adjoining panels. Ensure it is
flush to the bottom edge of the
panels as shown below.
Attach the Slamming Strip
onto the
opposite side you want the hinges,
onto the wall panel shown below.
DOOR WEATHER STRIP
(38 x 12 x 1710)
OUTSIDE
OUTSIDE
INSIDE
INSIDE
PLEASE
NOTE
Screwing the
door weather
strip onto the
side panel
determines
the side of
your hinges.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW
WALL
PANEL
FRAME
DOOR
WEATHER
STRIP
COVER STRIPS (40 x 12 x 1695) & (40 x 12 x 1925)
First attach the Smaller Cover Strip as shown
below.
You will need this to position your bar
table for the correct height.
Attach the Window Cover Strips with 30mm
screws. Position and ensure your Table Back
Piece is flush
end to end and sitting on the
Smaller Cover Strip underneath.
Fix with 70mm
screws.
Attach the Angled Braces to the Table Back
Piece.
Angle the screws to secure the braces
into place. Ensure the end Angled Braces are
flush to the edge and the other is central.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW
COVER STRIP (40 x 12 x 828)
3b
Attach the Top Table Piece.
Secure to
the Table Back Piece at each end and
in the centre. Then use 50mm screws
to secure to the angled braces.
Attach the
Top and Bottom Window Strips.
Repeat this process for the other window
opening. Ensure the strips are flush to the
window opening.
Secure the two
Window
Opening Side Strips
as shown below. Attach the middle Window
Cover Strip.
120
MM
SCREWS
COVER STRIPS (28 x 12 x 791) & (56 x 12 x 791)
WINDOW STRIPS (28 x 12 x 829)
WINDOW STRIPS (28 x 12 x 765)
COVER STRIP (40 x 12 x 890)
