Ford TRANSIT 2016.75, Руководство по монтажу

Страница: 245 / 292

Body to B-Pillar Bracket - Recommended Attachment Area
E176201
1
3
4
2
•
If implementing a fully sealed body air
extraction is required, the recommendation is
the use of one Ford service part
6G91_A280B62_A* on each side of the vehicle.
If this is not possible the alternative extractor
should provide 150cm^2 of cross sectional area
on each side of the vehicle. An ideal position
for the extractors would be in the back panel
of the cab. If this is not feasible, then the
extractors should be situated rearwards of
B-pillar such that there is a free airflow path
equating to the extractor effective CSA
maintained both upstream and downstream
of each extractor to maintain windshield
defogging performance and door closing
efforts. Extraction should not be installed near
exhaust components, or areas exposed to
potential fuel spillage.
•
It is recommended to fix the converters floor
by using additional U-type fixings around the
main rails and cross members or by using
screws running vertically through floor and rails,
cross members and outriggers. To eliminate
deformation of the rails during screwing
process, we recommend to use tubing
Refer to: 5.15 Frame and Body Mounting (page
281).
•
The Transit Motorhome Chassis and Ford
Skeletal Chassis offers most design flexibility
for adding a sidestep
•
Due to the wide side overhang it is
recommended to support the vehicle
converters floor
Refer to: 5.15 Frame and Body Mounting (page
281).
•
Do not cut or drill into areas as shown in figure
E168875
•
Drill only through the center line of rails and
ensure no spot weld is drilled out
•
The vehicle structure must not get preloaded
by the conversion structure or the assembly
process
Date of Publication: 03/2018
FORD TRANSIT 2016.75
5 Body and P
aint
245
EU