P/N: 4FA020-010
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
25MAR08 v4.0(86-93 5.0 Mus (4FA v4.0))
11
G. Clamp the provided rubber cap onto the vent fitting
on the throttle body.
H. With the 3/8” rubber hose, route blowby to the air filter
cover through the inline filter provided.
I.
1986-93 RENEGADE 5.0L KIT ONLY:
Install the supplied 4” aluminum elbow onto the
supercharger inlet using the silicone sleeve and #64
clamps. The inlet elbow is supplied with cast-in bosses
that can be drilled and threaded for a valve cover
breather fitting (Note: The engine valve cover vent
MUST be properly baffled or else the supercharger
may pull in oil from the engine). The aluminum elbow
can then be attached to the vehicles’ MAF and air
inlet filter. Vehicles equipped with an Anderson Power
Pipe can be easily adapted to the Vortech inlet elbow
by using the supplied 4” silicone sleeve and #64
clamps.
J. S.H.O. V-7 KITS ONLY: INNER FENDER AIR INLET KIT
1. Thread the supplied 3/8 x 90" x 1/4 NPT fitting
into the 4" aluminum inlet elbow.
2. Install the elbow onto the supercharger inlet using
the supplied silicone sleeve and #64 clamps.
3. Route the supplied 3/8" blowby hose from the
valve cover to the supercharger inlet elbow fitting
and trim if necessary. (Note: The engine valve
cover vent MUST be properly baffled or else the
supercharger may pull in oil from the engine).
4. Cut out the Vortech provided template. Using the
template, mark and drill the hole patterm into the
fender apron.
5. Remove the round plastic cover at the rear of the
oval opening on the inner fender.
6. Remove the plastic fender lining from the right
fender.
7. Attach the filter to the mass air flow (MAF) sensor
and secure with the clamp. Place the MAF in the
fender from the outside and secure with fasteners
provided from the engine compartment side.
8. Attach the short sleeve to the MAF and slip one
of the elbows inside the sleeve facing rearward
(see diagram).
9. Connect the 3" long sleeve to the rearward facing
elbow. Slip the second elbow through the round
hole to the engine compartment and secure into
the 3" sleeve.
13. AIR FILTER ASSEMBLY (skip to step I for Renegade applications)
cont'd.
NOTE: If kit is a High Output or Cobra model refer to
step 16, and Step J for S.H.O. applications.
Fig. 13-b
Front View
Fig. 13-c
Right Side View
