![Ford 2000 Windstar Скачать руководство пользователя страница 25](http://html1.mh-extra.com/html/ford/2000-windstar/2000-windstar_workshop-manual_2317442025.webp)
Is the wiper HI/LOW relay OK?
Yes
GO to
H3
.
No
INSTALL a new wiper HI/LOW relay. REPEAT the FEM self-test, CLEAR the DTCs.
H3
CHECK CIRCUIT 1319 (VT/WH) FOR SHORT TO VOLTAGE
FEM C191
Measure the voltage between FEM C191 Pin 3, Circuit 1319 (VT/WH), harness side and ground.
Is the voltage greater than 10 volts?
Yes
REPAIR Circuit 1319 (VT/WH). REPEAT the FEM self-test, CLEAR the DTCs.
No
INSTALL a new FEM. For additional information, REFER to
Section 419-10
. REPEAT the FEM self-test, CLEAR
the DTCs.
H4
CHECK WIPER HI /LOW RELAY — USE ACTIVE COMMAND SPEED RLY
Trigger the FEM active command SPEED RLY to ON.
Does the HI/LOW relay energize?
Yes
GO to
H5
.
No
INSTALL a new FEM. For additional information, REFER to
Section 419-10
. REPEAT the FEM self-test, CLEAR
the DTCs.
H5
CHECK WIPER HI/LOW RELAY
Wiper HI/LOW Relay
Check the wiper HI/LOW relay for correct operation. Refer to Wiring Diagram Cell 149.
Is the wiper HI/LOW relay OK?
Yes
GO to
H6
.
No
INSTALL a new wiper HI/LOW relay. REPEAT the FEM self-test, CLEAR the DTCs.
H6
CHECK THE CIRCUIT 1319 (VT/WH) FOR SHORT TO GROUND
FEM C191
Measure the resistance between FEM C191 Pin 3, Circuit 1319 (VT/WH), harness side and ground.
Page 25 of 30
2000 Windstar Workshop Manual
4/1/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYW/~MUS~LEN/21/S...