PINPOINT TEST H: THE HIGH/LOW WIPER SPEEDS DO NOT OPERATE CORRECTLY
No
INSTALL a new multifunction switch. For additional information, REFER to
Section 211-05
. REPEAT the FEM self-
test, CLEAR the DTCs.
G3
CHECK CIRCUIT 1321 (TN/BK) FOR SHORT TO GROUND
FEM C191
Measure the resistance between FEM C191 Pin 14, Circuit 1321 (TN/BK), harness side and ground.
Is the resistance greater than 10,000 ohms?
Yes
INSTALL a new FEM. For additional information, REFER to
Section 419-10
. REPEAT the FEM self-test, CLEAR
the DTCs.
No
REPAIR Circuit 1321 (TN/BK). REPEAT the FEM self-test, CLEAR the DTCs.
G4
CHECK CIRCUIT 1333 (LB/WH) FOR SHORT TO GROUND
FEM C191
Measure the resistance between FEM C191 Pin 5, Circuit 1333 (LB/WH), harness side and ground.
Is the resistance greater than 10,000 ohms?
Yes
INSTALL a new FEM. For additional information, REFER to
Section 419-10
. REPEAT the FEM self-test, CLEAR
the DTCs.
No
REPAIR Circuit 1333 (LB/WH). REPEAT the FEM self-test, CLEAR the DTCs.
CONDITIONS
DETAILS/RESULTS/ACTIONS
H1
USE THE RESULTS FROM FEM SELF-TEST
Use the recorded results from FEM self-test.
Are any DTCs recorded?
Yes
If DTC B1436, GO to
H2
.
No
GO to
H4
.
H2
CHECK WIPER HI/LOW RELAY
Wiper HI/LOW Relay
Check the wiper HI/LOW relay for correct operation. Refer to Wiring Diagram Cell 149.
Page 24 of 30
2000 Windstar Workshop Manual
4/1/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYW/~MUS~LEN/21/S...
