Yes
REPAIR circuit 1359 (DG/VT). REPEAT the FEM self-test. CLEAR the DTCs.
No
INSTALL a new FEM. REFER to
Section 419-10
. REPEAT the FEM self-test. CLEAR the DTCs.
C7
CHECK THE MULTIFUNCTION SWITCH FOR CORRECT OPERATION
Multifunction Switch C263
Check the multifunction switch for correct operation. Refer to Wiring Diagram Cell 149.
Is the multifunction switch OK?
Yes
GO to
C8
.
No
INSTALL a new multifunction switch. For additional information, REFER to
Section 211-05
. REPEAT the FEM self-
test, CLEAR the DTCs.
C8
CHECK CIRCUIT 1413 (VT/LB) FOR OPEN
FEM C347
Measure the resistance between FEM C347 Pin 5, Circuit 1413 (VT/LB), harness side and multifunction switch
C263 Pin 2, Circuit 1413 (VT/LB), harness side.
Is the resistance less than 5 ohms?
Yes
INSTALL a new FEM. For additional information, REFER to
Section 419-10
. REPEAT the FEM self-test, CLEAR
the DTCs.
No
REPAIR Circuit 1413 (VT/LB). REPEAT the FEM self-test, CLEAR the DTCs.
C9
CHECK THE FEM PID R_WPRUN
Monitor the FEM PID R_WPRUN.
Does the FEM PID R_WPRUN indicate ON?
Yes
REPAIR Circuit 1413 (VT/LB). REPEAT the FEM self-test, CLEAR the DTCs.
No
GO to
C10
.
C10
CHECK WIPER OPERATION — USE FEM ACTIVE COMMAND WIPER RLY
Activate, and deactivate, the rear wiper using the FEM active command WIPER RLY.
Did the rear wiper operate correctly?
Yes
INSTALL a new FEM. For additional information, REFER to
Section 419-10
. REPEAT the FEM self-test, CLEAR
the DTCs.
No
GO to
C11
.
C11
CHECK BJB FOR OPEN
BJB Fuse 8 (25A)
Page 14 of 30
2000 Windstar Workshop Manual
4/1/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYW/~MUS~LEN/21/S...
