36
MyCrown Design
4.5
Replacing the hard disk
4.5.1
Removing the back panel
✔
The unit is switched off and the power cable is disconnected.
1. Remove the 6 screws from the back panel.
2. Pull off the back panel parallel to the back. NOTICE! Observe the
ground cable and button connection.
3. Carefully pull away the ground cable on the device side and
disconnect the link to the button connection.
4. Put aside the rear panel.
4.5.2
Dismantling the hard disk
1. Unscrew and remove the 4 screws at the top.
2. Turn the sheet metal part out.
Содержание MyCrown Design
