4
Keypad Lock Retrofit Kit
10.
Tap all holes (except center front and center back
holes) with 8-32 tap.
11.
From door front, redrill center hole with 3/8" drill bit.
Warning: Do NOT try to drill completely through from one
side to the other.
12.
From door back, redrill center hole with 3/8" drill bit.
Warning: Do NOT try to drill completely through from one
side to the other.
13.
Install supplied grommets to center holes on front
and back side of door.
14.
Run wire cable connector through door from back to
front through grommeted holes.
15.
Attach lock to door back with 4 supplied screws.
16.
Push free end of wire cable connector through back
of center hole in keypad mounting base.
17.
Position mounting base with alignment pin at bottom
and attach door front with 2 supplied screws
(Fig. 7)
.
Fig. 7
18.
Install 2 supplied 9-volt batteries in keypad housing.
Fig. 8
19.
Plug wire connector cable into keypad circuit board
receptacle
(Fig. 9)
. Connector will fit only when ridge
on connector is aligned with slot on receptacle (see
Fig. 10
).
Warning: If connector does not slide easily into place,
check orientation of connector. Do NOT force.
Fig. 9
Содержание 00170688
Страница 7: ...Keypad Lock Retrofit Kit 7...
