Fohrenbach HT95, Руководство пользователя

Страница: 9 / 15

Instruction manual HT95 www.foehrenbach.be
Date : August 2007 Documentrev. : 3 Page : 9 / 15
4. PARTS REPLACEMENT PROCEDURE
4.1 Anvil Replacement (see figure 6)
NOTE
Replace anvils when they show excessive wear or are cracked or chipped.
4.1.1. Removal
When removing the anvil, the terminal holder (10) and guide pins (15) must also be
removed. Prior to removal, note the position of the guide pins in the anvil holder, so that
they can be positioned as they were before removal: the flat on the guide pins must face
the setscrews (12) in the anvil holder (4).
1. Loosen the two 2-56 setscrews (12) in the anvil holder (4) and remove terminal
holder assembly (10).
2. Remove 4-40 cap screw (9) from the damaged anvil(s) (5) and (7), or (6) and (8).
3. Remove damaged anvil.
4.1.2. Installation
NOTE
When replacing tooling, be sure that the part number of the part being replaced is the
same as the number of the part that was removed.
1. Loosely install the new anvil(s) to the anvil holder (4) with the 4-40 cap screw (9).
2. Close hand tool completely; this aligns anvil to the crimper. Tighten the 4-40 cap
screw (9), and release the lever.
3. Re-install terminal holder (10) to the anvil holder (4) and tighten the two 2-56
setscrews (12).
4. Crimp a terminal to a proper-sized wire, and inspect the terminal as described in
Section II, paragraph B.