FOG QUADRA 493 9021, Установка, эксплуатация и обслуживание

Страница: 9 / 60

QUADRA
9
E 167 - GB - 6
Rue du Pré Neuf - 58440 MYENNES FRANCE
493 9021
493 9031
Component position
Position on the floor plan all of the components that make up the lift, in the following order:
• Cross-members: Place a suitable support under the cross-members, and under the horizontal gusset.
• Columns: Engage the columns as far as possible onto the vertical cheek-plates of the cross
members and position them correctly on the floor, move the cross-members if necessary.
• Fixed track: Place the fixed track on the cross-member horizontal gussets, with its wheel guide
flange facing inwards. Locate the connecting screws (Fig. 5) but do not tighten them. Pay
attention to the position of the wire rope guide screws.
• Adjustable track: Place the adjustable track on the cross-members as far as possible from the
fixed track and with its wheel guide flange facing inwards. Move the ends of the cross-
members so the track can fit in-between them in order to give 2 to 3 mm clearance between
the cross-member beam and the bosses at each end (Fig. 6). Tighten the connecting screws to
secure the horizontal gusset onto the fixed track.
Platform level adjustment
Adjusting the amount of shims under the cross-members. To ensure that the platform is level. This can be
verified as follows:
• laterally, using a spirit-level on the cross-members.
• longitudinally, using a spirit-level in the centre of the track.
Column adjustment
Measure and compare the distances between the column base plates and the ends of the cross-members.
A difference of 15 mm can be accommodated by adjusting the ladder rack in the column. If the difference
is greater than this, the lowest column(s) should be raised by placing shims under the base plate(s) or by
using the lifting screws.
Maintain the position of the base plate on the floor plan, then check each column in succession as follows:
• Whether it is vertical, using a plumb-line. If not, place shims under the base plate or adjust the
lifting screws.
• Whether it is square, using a rule placed on the main inside face of the column and sighting
the column opposite.
• Whether there is clearance of
1
mm between the roller on the end of the cross-member and
the inside of the column (Fig. 14).