FOG QUADRA 493 9021, Установка, эксплуатация и обслуживание

Страница: 26 / 60

E 167 - GB - 6
26
Rue du Pré Neuf - 58440 MYENNES FRANCE
QUADRA
493 9021
493 9031
MAINTENANCE
General
The lift and suspension parts (wire ropes) and safety systems must be examined at least every six months by
an authorised competent person More frequent checks will be necessary if the lift is continual use.
The lift must be thoroughly examined following any major repair or modification involving its main components.
These tests and examinations must only be carried out by an authorised competent person. The result and
date of this test or examination as well as the name, occupation and address of the person who has carried
it out, must be recorded in a log or notebook that includes the identification details of the lift.
Monthly Maintenance (or three-monthly if the lift is used infrequently)
• With the platform on the ground, check the oil level, or once a year, drain the oil reservoir.
Use the following types of oil:
- 493 9031 (including auxiliary lift)
Only use hydraulic oil ref. 256 8011, 5 litres Engler viscosity = 4 to 5 degrees at 20° C.
- 493 9021 (without auxiliary lift) hydraulic or engine oil S.A.E. 10 W 30.
• Lubricate the cam, latch and wire rope sensor pins with a light oil.
• Clean the platform suspension wire ropes. Check that no wire rope has come out of the pulley
grooves and inspect each rope over its entire length.
NOTE: a thin or frayed wire rope must be replaced.
• Check that there are lock nuts on the wire rope end fittings. Using the appropriate personal
protective equipment e.g. gloves, generously grease the wire ropes with the recommended
grease.
Annual lift test
Check the wire rope adjustment as follows:
• Place the unloaded platform in its bottom position and ensure that no cross-member end is
resting and causing mechanical wear on the column base plate. (NOTE: The distance between
the bottom of the cheek plate and the top of the base plate must at least 60 mm).
• Position a vehicle weighing between 1500 kg and 2200 kg on the platform. Raise the
platform to eye-level, suspended on the wire ropes and check that dimension X (Fig. 13) is
more or less the same for all four columns. If necessary, adjust the wire ropes.
Fig. 13
‘LOWER’ Lever
Cross member
vertical gusset
Ladder