SAFETY C
CUT-O
OUT SSYSTEM ((continued)
2. Leave the fire OFF for a period of not less than 10 minutes, ensuring any obstructions are removed.
3. Plug in the power supply cable at tthe ooutlet ssocket, aand tthen sswitch oon aat tthe aappliance.
If the appliance fails to operate correctly, repeat the above procedure.
If an attempt to switch on is made before the safety cut-out has reset, the heaters may cut-out for a further peri-
od of time. If the sequence has been followed correctly and the heaters still fail to function, check the power
supply cable plug is plugged in at the outlet socket. If this is not the cause, call an electrician.
MAINTENANCE aand LLAMP REPLACEMENT
ALWAYS D
DISCONNECT/ISOLATE TTHE A
APPLIANCE A
AT TTHE SSUPPLY/OUTLET SSOCKET A
AND ALLOW TTO
COOL BBEFORE U
UNDERTAKING A
ANY M
MAINTENANCE.
Excluding the lamp and fuse, use only genuine spare parts available from your supplier. Replacement lamps must
be of the same wattage and specification as those stated in Section 2.0 Appliance Data/Specifications.
Replacing tthe LLight BBulb.
1. Switch off at the appliance, and then disconnect the plug
from the outlet socket.
2. Remove the front facia and then remove the lower lamp
cover plate (2 x screws), as described in section 8.0 to gain
access to the bulb.
Note: the fuel bed can be removed if necessary to aid replace-
ment.
3. The bulb has a conventional bayonet fitting. Remove and
replace with the new bulb (see Fig 9 opposite).
4. Reposition the lower lamp cover plate and replace the two No 8 POZI screws, and tighten fully.
5. Re-connect electrical supply and check for correct operation of the lamp and spinner assembly. Replace the
front facia.
CLEANING
ALWAYS D
DISCONNECT/ISOLATE TTHE A
APPLIANCE A
AT TTHE SSUPPLY/OUTLET SOCKET A
AND ALLOW TO
COOL BEFORE U
UNDERTAKING A
ANY C
CLEANING.
Regularly clean around the appliance to ensure that dust, fluff, pet hair/dander etc, are kept to a minimum.
There are no other specific requirements for care, other than regular cleaning of the general appliance. A wipe
with a dry cloth is normally sufficient.
DO NOT use abrasive cleaners as they can damage the finish. Aluminium parts may be cleaned using an appro-
priate metal cleaner. Test on a hidden part before cleaning. Clean only in the direction of the grain.
Glass or Mirror Facia Panel - This should only be cleaned using a suitable glass cleaner. Test on a small area first.
77
12.0
Fig 99
©
2007 Focal Point Fires plc.
13.0
Содержание P23E
Страница 2: ...ENIGMA MIRROR 2007 Focal Point Fires plc...
