FocalPoint P23E, Инструкция по установке и эксплуатации

Страница: 7 / 12

FIXING TTHE A APPLIANCE ((continued)
the screws protruding approximately 6mm from the wall.
The appliance can now be “hung” onto the two upper wall fixings, ensuring that the heads of the screws go
through the keyhole shaped holes, and then drop down into the keyhole upper slot.
Ensure that the lower rear panel fixing hole aligns with the wall plug, and then insert 1 x 37mm long fixing screw
and fully tighten.
Finally fully tighten the two upper fixing screws, through the two panel access holes at the front of the appliance,
and ensure that the appliance is firmly and securely attached to the wall.
c) R Re-aassembly oof A Appliance:
Note: re-assembly is the reverse of disassembly as described in section 8.0
1. Refit the fuel bed, ensuring that the lamp spinner is free to rotate, see previous figure 2.
2. Refit the lower lamp cover plate, firstly inserting the bottom edge behind the lower firebox lip. Secure with
the two screws previously removed, see previous figure 1.
3. Finally, peel off any remaining protective plastic coatings on the front frame, curved backpanel and the plas-
tic fuel bed.
d) PPlacement oof PPebbles:
Unpack the pebbles and arrange them over the fuel bed. The final
pebble arrangement can only be done later when the lamp is
switched on and light shines up through the transparent cover.
The ideal pebble layout is shown in figure 5.
Ensure that all pebbles are placed such that they avoid any danger
from falling off the appliance.
e) H Hanging tthe FFront G Glass oor M Mirror FFacia ::
Remove the glass or mirror facia panel from its protective packaging.
The facia panel is supported on the appliance by four M6 screws which
protrude from brackets on the front of the outer casing.
See figure 6. Note glass facia shown, mirror facia attaches in identical way.
Ensure each screw is
unscrewed approximately
one turn from the fully
screwed in position in order
to create a 2mm gap.
See figure 7.
Simply hang the facia panel onto the outer casing ensuring that the corresponding keyhole shaped holes engage
the screwheads fully.
5 ©
2007 Focal Point Fires plc.
Fig 55
2mm
Fig 6
Fig 7