FUEL BED LAYOUT (continued)
The coals may be rotated slightly within their positions to give a good visual effect. Pay special attention to finally adjust the coals with the
fire lit on the HIGH setting in order to ensure that no flames play onto the firebox sides. This will reduce the possibility of heat discolouration.
The fire is designed to operate correctly with the coals supplied when assembled according to the instructions. Never add to the eleven coals,
or change them for a different type. Never throw rubbish or other matter onto the fuelbed.
FUEL BED LAYOUT - Pebble effect option (Natural Gas Only)
This fire is supplied with 15 ceramic pebbles. The pebbles may vary slightly in size, shape and colour, in order to allow a realistic layout.
Place the brick panel against the rear of the firebox
Place the ceramic combustion matrix onto the burner and the ceramic side
cheeks onto the matrix.
Place the front row of six pebbles on to the matrix. Ensure the pebbles are
firmly against the side cheeks as shown in the photograph. If necessary, pull
the pebbles forward slightly to ensure their rear edges do not overhang the
flame ports. The edges of the pebbles MUST NOT be allowed to enter the
flame ports.
Place the middle row of four pebbles onto the supports in the matrix, over the
top of the holes. Ensure the pebbles are not turned sideways, such that they
actually enter the holes.
Place the rear row of five pebbles, making sure that the flat sides are firmly
against the brick panel and side cheeks as shown.
Note: The pebbles must not be crammed together, or inserted into the holes
in the matrix. A well laid out, generously spaced pebble layout will give the
best results.
The pebbles may be rotated slightly within their positions to give a good visu-
al effect. Pay special attention to finally adjust the pebbles with the fire lit on
the HIGH setting in order to ensure that no flames play onto the firebox sides. This will reduce the possibility of heat discolouration.
The fire is designed to operate correctly with the pebbles supplied when assembled according to the instructions. Never add to the fifteen
pebbles, or change them for a different type. Never throw rubbish or other matter onto the fuelbed.
FITTING THE DECORATIVE FRAME
The appliance is supplied with a decorative frame in a variety of finishes. The frame is held onto the firebox by one of two methods; either by
magnetic pieces fitted to the steel backing plates, or as a three piece clip-on assembly.
If not pre-fitted, the clip-on frame pieces should be hooked over the outer edges of the fireframe, and pushed firmly home. The sides should
be fixed first, followed by the top bar, which overlaps the sides. Push firmly home. A plastic protective film may be applied to the outside of
the frame and should be removed at this stage.
Place the decorative firefront in front of the fire and slide the ashpan door into place. The firefront shown in these instructions may be dif-
ferent to the one supplied with the appliance.
8
9.0
10.0
9.1
©
2010 Focal Point Fires plc.
