FITTING THE DECORATIVE FRAME ASSEMBLY
Remove any protective packaging, and remove any protective
film that may be present on the frame.
Pinoir and Memoirs models : Remove the stone facia panel from
any protective packaging. The stone facia panel is supported by
four M6 screws which protrude from the front of the outer cas-
ing.
Ensure each screw is unscrewed approximately one turn from
the fully screwed in position in order to create a 2mm gap
(shown). Hang the facia panel onto the outer casing ensuring
that the corresponding keyhole
shaped holes engage the screw-
heads fully.
Reflection models : The front
section of the frame assembly
should now be fitted. Remove
the extruded frame assembly
from the packaging. Position the frame onto the front of the
fire, ensuring that the inside edges of the frame are pushed up
to the stainless steel window frame fully. Insert four retaining
screws in the positions on the side of the firebox as shown.
Saturn models : The front section of the frame assembly should
now be fitted. Remove the painted frame assembly from the
packaging. The frame is supported by a hanging bracket at the
top centre of the frame. Hang the frame onto the correspon-
ding bracket on the front of the fire, ensuring that the inside
edges of the frame are pushed up to the window fully. Insert
two retaining screws in the positions on the side of the firebox
as shown.
BRIEFING THE CUSTOMER
All instructions must be handed to the user for safekeeping.
Show the customer how to light and control the fire. After
commissioning the appliance, the customer should be instruct-
ed on the safe use of the appliance and the need for regular
servicing. Frequency of service depends on usage, but MUST
be carried out at least once annually. Advise that cleaning of
the fire maybe achieved when the fire is cold using a damp
cloth and mild detergent on most surfaces. Advise that the fire
will emit a "newness" smell for a time after initial commissioning and that extra ventilation may be needed during this
time. Recommend that a guard be used for the protection of the young, pets, the elderly and the infirm
SERVICING
Isolate the fire from the gas supply. Ensure that the fire is fully cold before attempting service.
A suggested procedure for servicing is detailed below.
1. Lay out the dustsheet and tools.
2. Remove the decorative frame/glass facia assembly. Removal is reverse of section 8.4.
3. Remove the glass door assembly (4 screws) and clean carefully.
4. Inspect the burner and the catalyst and clean if necessary with a soft brush.
5. Disconnect the gas supply.
6. Detach the burner front cover plate by removal of the four retaining screws. Undo the four screws retain-
ing the burner support brackets to the base and rear of the firebox. Remove the control knob and spindle
assembly from the valve by removal of the spindle retaining clip.
7. Remove the burner unit, strip off the burner pipes and clean thoroughly.
8. Clean the in-line restrictor, pilot assembly and the burner tube. Do not attempt to remove the pilot injec-
tor as this can cause damage.
9. Re-assemble components.
10. Turn on the gas supply and leak test. Check pilot and burner for good ignition.
11. Refit the glass door assembly, ensuring correct orientation and a good seal.
12. Refit the decorative facia/frame assembly as detailed in section 8.4.
7
8.4
10.0
9.0
2mm
©
2008 Focal Point Fires plc.
Pinoir and Memoirs models
Reflection models
Saturn models
