Foamit APW20HT, Руководство пользователя, Страница: 9 / 14

Model: APW20HT V20190916 • Page 9
1 . Lift the sink up from the base.
2 . Fill the base with the aqueous
based solution. Important! Do
not fill higher than the maximum
fill line. The equipment has a
maximum capacity of 20 gallons
(75.7 liters).
3 . After the base is filled, place
the control box assembly and
sink back onto the base,
re-connect the supply hose if
necessary, and open the lid.
Important! Always ensure the
heater is submerged in the
solution during operation of
the equipment. Do not run the
equipment if the heater is not
submerged in the solution. This
will damage the unit.
4 . Press the heater on/off switch
and turn the heater On. Note: It
takes about 1 1/2 hours to heat
very cold solution to 105° F
(40.5° C).
5 . Press the pump on/off switch
and turn the pump On.
6 . Place the parts in the sink.
Important ! Do not overfill
the sink. Maximum weight of
the part(s) should not exceed
400 lbs.
4 Use
Important! Only aqueous (water) based solutions shall be used with this equipment. It is beyond the scope of this
manual to describe every aqueous based solutions available. It is the user’s responsibility to ensure the use of
proper solutions with this equipment.
Chemical solutions must be formulated for this type of application and compatible with unit materials and pump
seals. Always read, and follow, all chemical safety precautions and handling instructions provided by the solution
manufacturer and the Safety Data Sheet (SDS) associated with the solution being used before using the equipment.
Never use any amount of non-aqueous solvent with this equipment.
Follow these steps to use the equipment:
LOW FLUID
AT TEMP
R
I
N
S
E
B R U S H
Fire and explosion hazard.
No solvents, mineral spirits
or other flammable products.
Use only water based cleaners.
Drain parts of flammable contents.
!
Read and follow user manual and
warning to avoid rish and serious injury
or death.
Know hazards of your chemical. Read
and follow safety data sheets (SDSs).
!
ON
OFF
ON
OFF
LOW FLUID
AT TEMP
R
I
N
S
E
B R U S H
Fire and explosion hazard.
No solvents, mineral spirits
or other flammable products.
Use only water based cleaners.
Drain parts of flammable contents.
!
Read and follow user manual and
warning to avoid rish and serious injury
or death.
Know hazards of your chemical. Read
and follow safety data sheets (SDSs).
!
ON
OFF
ON
OFF
Maximum
fill level
The AT TEMP
light will come on
when the solution
temperature
reaches 105° F
(40.5° C)
The low fluid light
will flash when
the solution level
is below the float
switch and the
control box will
turn off.
3
4
2
5