©2003 FoamFly.com
6
d) Peel the two Firewall formers and glue them to each other
Take a look at the two Firewall formers. Decide which face of each you’d
like to see, and peel the complete opposite side. Glue the two fuselage
formers back to back with their tops aligned.
e) Cut Holes in the Firewall formers as noted. (See the plans.)
f)
You’ll need to make holes in the Firewall both for the motor stick, and
for the motor wires to pass through. If you’re unsure, smaller holes are
preferable, so the motor stick will be tight fit in the foam.
g) Glue the Firewall Formers, and the Hood Former to one half.
Glue both the Firewall & Hood Formers to one side of the fuselage. They
should align perpendicular to the hood line, with the ‘lip’ on the former
hooking on the top edge of the fuselage.
h) Glue the Fuse Bottom and the Fuse Front to that same half.
Grab your Fuselage Bottom piece, and glue it into the matching slots on the
fuselage half that you’ve been working on. Make sure you get glue on both
the faces and side of the tabs. Everywhere the foam will be in contact.
