9
105383
OWNER’S MANUAL
INSTALLATION
Continued
5.
Attach gas log heater base to firebox
bottom using instructions provided
with log set owner’s manual.
6.
Replace firebox bottom and secure with
screws.
NOTICE: Most building codes do
not permit concealed gas con-
nections. A flexible gas line is
recommended to allow accessi-
bility from the firebox. The flex-
ible gas supply line connection
to the manual shutoff valve
should be accessible.
Figure 10 - Removing Firebox Bottom
1.
Remove four screws holding firebox
bottom in place.
2.
Lift and remove firebox bottom (see
Figure 10).
3.
If installing FA3700 Blower Accessory
(Model UV32C only), see Installing
Blower Accessory, page 8.
4.
Route flexible gas line from manual
shutoff valve into firebox through side.
INSTALLING LOG HEATER IN
FIREBOX
CAUTION: Do not pick up log
base assembly by burners. This
could damage burners. Only
handle base by grates.
INSTALLING FIREPLACE
SCREEN
1.
Insert each rod through nine rings lo-
cated at top of screen.
2.
Insert first rod into rear hole in left side
of firebox. Fasten rod to rear hole near
center of firebox using black shoulder
screw.
3.
Insert other rod into front hole on right
side of firebox and fasten using remain-
ing shoulder screw.
Figure 11 - Installing Fireplace Hood
Hood
Hood
Mounting Slot
Screw
Shoulder
Screw
INSTALLING FIREPLACE
HOOD
1.
Attach three zinc-colored shoulder
screws to back of hood.
2.
Insert hood into hood-mounting slots
on firebox.
3.
Hold hood in place. Insert two black
Phillips screws through bottom of hood
and tighten.
Figure 12 - Installing Fireplace Screen
(Shown Without Fireplace Hood for
Clarity)
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,
Rod
Front
Hole
Ring
Screen
Screw
Rear Hole
Continued
CAUTION: Do not remove the
metal data plates attached to the
heater base assembly. The data
plates contain important warranty
information.
