5
❏
7. From the
right side
of the fi n holder install two
2mm x 8mm machine screws. Tighten the screws
until the fi n fi ts snug in the fi n holder. Be careful
not to overtighten the screws.
❏
8. Remove the pushrod retainers from the
pushrod wires. Slide the wire into the outermost
hole in both the rudder and elevators’ control
horns, and then re-install the pushrod retainers.
INSTALL THE LANDING GEAR
❏
1. Slide the
tail wheel wire
into the slot on the
bottom of the fuselage.
❏
2. Place the plastic tail wheel retainer over the
landing gear slot. Secure it to the fuselage with
2mm x 5mm sheet metal screws.