background image

2

PROTECT YOUR MODEL, YOURSELF

AND OTHERS; FOLLOW THESE 

IMPORTANT SAFETY PRECAUTIONS

Your Beechcraft Staggerwing should not be 
considered a toy, but rather a sophisticated, working 
model that functions very much like a full-size 
airplane. Because of its performance capabilities, 
the Beechcraft Staggerwing, if not assembled and 
operated correctly, could possibly cause injury to 
yourself or spectators and damage to property.

We highly recommend that you get experienced, 
knowledgeable help with assembly and during 
your fi rst  fl ights. This will make your modeling 
experience more enjoyable. You’ll learn faster 
and avoid risking your model before you are 
truly ready to fl y solo. Your local hobby shop has 
information about fl ying clubs in your area whose 
membership includes qualifi ed  instructors.  You 
can also contact the National Academy of Model 
Aeronautics (AMA), which has more than 2,500 
chartered clubs across the country. Instructor 
training programs and insured newcomer training 
are available through any one of these clubs.

Contact the AMA at the address or toll-free phone 
number below.

Academy of Model Aeronautics

5151 East Memorial Drive

Muncie, IN 47302

(800) 435-9262 Fax: (765) 741-0057

or via the Internet at: 

www.modelaircraft.org

FCC REQUIREMENT

This device complies with Part 15 of 
the FCC Rules. Operation is subject 
to the following two conditions: (1) 

This device may not cause harmful interference, 
and (2) This device must accept any interference 
received, including interference that may cause 
undesired operation.

CAUTION: Changes or modifi cations to this product 
not expressly approved by the party responsible 
for compliance may void the user’s authority to 
operate the equipment.

PRECAUTIONS

1. Assemble the plane 

according to instructions

DO NOT 

alter or modify the model. If you make 

any modifi cations, you void your warranty.

2. 

Test

 the operation of the model 

before each fl ight

to insure that all equipment is operating properly 
and that the model remains structurally sound.

3. Fly only on calm days (with wind speeds less 
than 5mph) and in large, open areas free of trees, 
people, buildings, or any other obstacles.

Remember: Take your time and follow the 
instructions to end up with a well-built model that 
is durable and easy to fl y.

The R/C model hobby becomes more and more 
enjoyable as your experience grows. Your chances 
for success and graduation to higher levels are 
very good if you take your time and follow the 
assembly and fl ying instructions carefully and 
completely. We hope you enjoy fl ying  your 
Beechcraft Staggerwing.

GLOSSARY

Electronic Speed Control/Receiver (ESC/RX):

 

This unit controls the speed of the motor and 
control surfaces.

Elevator:

 The moving surface on the horizontal 

stabilizer that controls the pitch of the airplane 
causing it to climb or descend.

Rudder:

 The moving surface on the vertical fi n 

that controls movement of the airplane to the left 
or right.

Nickel-Metal Hydride (NiMH) Battery:

Rechargeable batteries which are used to power 
the airplane. NiMH batteries are lighter and smaller 
than most other types of rechargable batteries.

Transmitter (TX):

 This is the hand-held unit that sends 

the signal to the control unit (or RX). Moving the 
sticks controls altitude and direction. The throttle 
lever on the back of the transmitter controls speed.

Содержание beechcraft staggerwing

















Отзывы: