9
5.4
D/R
ST.D / R is for servo travel adjustment, which can be multiplexed as CH2 (throttle), CH3, CH4
s e r v o t r a v e l a d j u s t m e n t , s e e [ 5 . 5 M o d e S w i t c h ] f o r m u l t i p l e x s w i t c h i n g m o d e ;
Adjustment range: 0-120%(the default is 100%), the step is 5%.
S T. D / R + : i n c r e a s e s e r v o t r a v e l .
ST.D / R -: decrease servo travel.
LED Indicator:
•
When using the trim keys the G.LED will flash slowly on short presses and quickly on long presses.
•
When the ratio value is at both ends (0/120%), the ST.D / R button is at its maximum and as such G.LED
will not flash(if the ratio value has been adjusted to 120%, then press ST.D/R+ key is invalid and G.LED
has Instructions)
5.5
Mode Switching
This function is for reusing the ST.TRIM and ST.D / R buttons for different channels (see [5.3
Trims], [5.4 D/R).
F u n c t i o n s e t t i n g :
Under normal power-on, quickly press the Bind button twice (within 1 Sec) to cycle through modes
1 , 2 , 3 , a n d 4 . T h e d e f a u l t s e t t i n g w h e n p o w e r i n g o n i s m o d e 1 .
Mode 1: G.LED flashes slowly once, ST.TRIM is CH1 fine adjustment, ST.D / R is servo travel
a d j u s t m e n t .
Mode 2: G.LED flashes twice slowly, ST.TRIM is CH1 fine adjustment, ST.D / R is CH2 servo travel
a d j u s t m e n t .
Mode 3: G.LED flashes three times slowly, ST.TRIM is CH3 fine adjustment, ST.D / R is CH3 servo
t r a v e l a d j u s t m e n t .
Mode 4: G.LED flashes slowly four times, ST.TRIM is CH4 fine adjustment, ST.D / R is CH4 servo
t r a v e l a d j u s t m e n t .
5.6 Failsafe
T h i s f u n c t i o n p r o t e c t s t h e u s e r b y p r e v e n t i n g t h e m o d e l f r o m b e h a v i n g u n e x p e c t e d l y i f s i g n a l i s
l o s t .
T h e t r a n s m i t t e r i s d e f a u l t s e t a s n o s i g n a l o u t p u t w h e n f a c i n g m a l f u n c t i o n a s t h e F a i l s a f e
P r o t e c t i o n .
