eyelet with approximately 20 cm / 8 in. of the boundary
wire.
Note:
Make a blueprint of the work area before you
install the boundary wire and guide wire.
D
E
B
C
F
A
•
Put the boundary wire around all of the work area
(A). Adapt the distance between the boundary wire
and obstacles.
•
Put the boundary wire 35 cm / 14 in. (B) from an
obstacle that is more than 3.5 cm / 1.4 in. high.
35 cm /14
"
> 3.5 cm / 1.4
"
•
Put the boundary wire 30 cm / 12 in. (C) from an
obstacle that is 1-3.5 cm / 0.4-1.4 in. high.
1-3.5 cm / 0.4-1.4
"
30 cm / 12
"
•
Put the boundary wire 10 cm / 4 in. (D) from an
obstacle that is less than 1 cm / 0.4 in. high.
10 cm / 4
"
max 1 cm / 0.4
"
•
If you have a paving stone path that is in level with
the lawn, put the boundary wire below the paving
stone.
Note:
If the paving stone is minimum 30 cm / 12
in. wide, use the factory setting for the
Drive Past
Wire
function to cut all the grass adjacent to the
paving stone. Refer to
page 21
.
•
If you make an island, put the boundary wire that
runs to and from the island near together (E). Put
the wires in the same stake. Refer to
.
•
Make an eyelet (F) where the guide wire is to be
connected to the boundary wire.
14 - Installation
1622 - 001 - 03.03.2021
