9
EN
10. Control panel
11. The “
i
” button on the On-board computer
activates the display function.
12. Reduce value/scroll down “
–
” button
13. Increase value/scroll up “
+
” button
14. Pushing aid button “
WALK
”
Switching the pushing aid on and off
The pushing aid can make it easier for you to push
the e-bike. All FLYER are equipped with a pushing
aid. This is limited to 6 km/h in the highest gear.
By pressing the
«WALK»
button
14
, the FLYER
can be easily pushed out of the underground ga-
rage or over a steep passage.
To acti ate the pushing aid, briefly press the
«WALK»
button on your on-board computer. Af-
ter activation, press the
«+»
button within three
seconds and hold it down. The E-bike drive will
be switched on.
The pushing aid cannot be activated in
support level
«OFF»
.
The pushing aid is
switched off
as soon as one
of the following events occurs:
• You release the
«WALK» 14
button,
• The wheels of the E-bike are blocked (e.g. by
breaking or bumping against an obstacle)
speed exceeds 6 km/h or 1 km/h
With certain systems, the pushing aid
can be started directly by pressing the
«WALK» button.
When using the pushing aid, the wheels
must be in contact with the ground to
avoid the risk of injury.
Switch lighting on/off
The headlight and the rear light can be switched
on and off at the same time by pressing the button
2
on the on-board computer when the respective
bicycle version supplies the riding lights from the
E-bike system. As a general rule, S-pedelecs with
pedal assist up to 45 km/h have a daytime run-
ning light. The lighting will automatically turn on
when you switch on the system. The button
2
will
not turn off the light.
Setting the electrical support level
You can use the on-board computer 10 to confi
-
gure the level of assistance provided by the E-bi-
ke drive when you are pedalling. The assistance
level can be adjusted at any time, including during
your ride.
Certain versions have a preset assis-
tance level that cannot be changed. Cer-
tain models may also have fewer assis-
tance levels to choose from than are
shown here.
f the E-bike was configured with eMTB
mode ex works, the SPORT assistance
level is replaced by eMTB. In eMTB
mode, the assistance factor and the
torque are adjusted dynamically de-
pending on the pedal force applied to the
pedals. eMTB mode is only available
with Performance Line CX drives.
The full range of assistance levels includes:
• OFF
motor assistance is switched off the E-bike
is operated like a normal bicycle through pedalling
alone. The pushing aid cannot be activated in this
assistance level.
• ECO
effecti e assistance with optimum e ciency
for maximum range.
• TOUR
: consistent levels of assistance for tours
with large ranges.
SPORT/eMTB
:
• SPORT
: powerful assistance for active riding on
hilly terrain and in city tra c.
• eMTB
: optimum assistance on any terrain, fast
acceleration, impro ed dynamics, maximum per
-
formance
• TURBO
maximum assistance up to high pedalling
frequencies for active riding
Increase the electrical support level by pressing
the “
+
”
button
13
on the operating unit until the
desired electrical support level is shown at Indica-
tor
b
or lower the value by pressing the “
–
”
button
12
. The motor power requested is shown on the
display
a.
The maximum motor performance de
-
pends on the electrical support level chosen.
14
13
11
10
12
