41
Provincial Road n.78 Km 12.150
33050 Mortegliano (UD) – Italy
Tel. +39.(0)432.992482 – +39.(0)432.993557
Fax +39.(0)432.931280
Sito web:
www.flysynthesis.com
e-mail:
Maintenance Manual
FLY SYNTHESIS TEXAN
TOP CLASS 580 ISR
(For Rotax 912 ULS
versions)
Identification: MM_TC_580_Rev.2
Page: 41 of 77
Date: 15/02/11
Issued: C. Cosatto
Verified: C. Cosatto
Approved: C. Cosatto
Revision Description:
Placard update
TYPE
TASKS TO BE PERFORMED
25
50
100
200
Check tightening of nuts securing aileron and flap hinges
(support plates) in wings.
O
O O
Check tightening of self-locking nuts securing the aileron
And flap control rod end ball joints (inside fuselage/
wing).
X
X X
Check aileron push pull rods support in fuselage for
tightness of nuts.
X
X
Check elevator control rods support in fuselage for
tightness of nuts
X
X
WING
Check for loose screws In wing tip connection upper and
lower surface,
O
O O
Inspect wing surfaces condition for defect, no serious gel
coat chips, delamination or scratches
O
O O
Check fuel tank and outlet for security and leaks. Check
the fuel lines from the tank to the firewall for condition
and support. This may be done via the Inspection port
O
O O
COCKPIT
Carefully inspect all operating levers for damage, wear,
abnormal play and security of attachment. Clean and
lubricate as required.
X
X X
Check electric wiring and electric component installation,
for condition and attachment
O
O O
Clean the floor
X X X X
Inspect pilot seat belts. Check operation of locking
mechanism. Check bolts and nuts securing the seat
belts.
X
X X
Check instrument panel and instruments attachment.
Check instruments connection, static and dynamic line.
O O O O
Check instruments marking per AFM limitations
X X
Drain static and dynamic line.
O
O O
Check radio and navigation instrument, and antenna line. O O O O
Check the canopy, no scratches or damage. Clean the
canopy. and lock security, lubricate as necessary.
O O O O
Check canopy four locks for correct operation, secure
locking and maintaining locked position, unlocking
O O O O
LANDING
GEAR
Remove fairing from wheels and struts
X X
Check nose landing gear structure for cracks and
alignment, attachment and bolt tightness.
X X X X
Disassemble nose gear strut, check attachment of nose
gear plate to firewall, plate to strut, reassemble, check
bolts tightness.
X X