
38
Provincial Road n.78 Km 12.150
33050 Mortegliano (UD) – Italy
Tel. +39.(0)432.992482 – +39.(0)432.993557
Fax +39.(0)432.931280
Sito web:
www.flysynthesis.com
e-mail:
Maintenance Manual
FLY SYNTHESIS TEXAN
TOP CLASS 580 ISR
(For Rotax 912 ULS
versions)
Identification: MM_TC_580_Rev.2
Page: 38 of 77
Date: 15/02/11
Issued: C. Cosatto
Verified: C. Cosatto
Approved: C. Cosatto
Revision Description:
Placard update
Control sticks
Control rods connected securely (visible part
only) free and full movement.
Rudder pedals
No distortion, rudder and nose wheel aligned,
Nose wheel control rods and rudder control
cables securely attached, condition, rubber
(shock cord)
centering cables condition good.
Throttle and choke
Free and smooth movement, installed
securely.
Brake lever and parking brake
Release parking, brake lever operates
smoothly, correct feel. Engage parking.
Trim lever
Installed securely, free and smooth movement.
Seat belts
Undamaged, locking device locks and
releases freely.
Seats Fixed
Correctly located in required position.
Canopy
Clean, undamaged, freedom of movement.
four locks operate correctly,
Windshield
Clean, fixed securely.
Baggage
Not exceeding weight limit, weight distributed and
load secured.
Weight and balance
Calculate.
Aircraft log book
Record the Daily Inspection in the book.
9.5 SCHEDULED INSPECTION CHART
Legend: O = only requires a visual check X = complete check, may require tools.
NOTE:
Prior to working around the cockpit area, place a suitable protective covering over
the wing surface such as a rubber mat. Prolonged kneeling on the wing surface without
protection may cause indentation or even delamination.
TEXAN ISR - SCHEDULED INSPECTIONS
– PROGRAM
INSPECTION
TYPE
TYPE
TASKS TO BE PERFORMED
25
50
100
200
GENERAL
Ensure that ignition switches are OFF and master switch
(key) is REMOVED
X X X X
Open all inspection panels in the fuselage and wings.
X
X X
Remove seats and seat back
X X X X
Remove floor below the seats (part TB0200) unless
suitable special video equipment is used for inspection.
X
X
Remove floor below the seats (part TB0200)
X
Remove Engine cowling, top and bottom.
X X X X
Expose underside fuselage wing root fairing both sides
X
X X
Check all rivets to detect loose rivets. Any loose rivet
shall be replaced with oversize rivet
O
O O