MAX OWNER’S MANUAL VER . 2.0
___________________________________________________________________________
©
Copyright di
FLY
Products
s.r.l.
Pagina
14
Spark plug
Set the spark plug gap to 0.025” (0.635mm). Install the spark plug and torque to specifications
(120-inch lbs. or 10 ft- lbs.).
Assembly inspection
It is critical to fully inspect the assembly of the
MAX
to find and remedy any potential problem areas
before proceeding.
The inspection should contain, at a minimum, the following items:
?
Review each assembly step above
?
Examine all nuts, bolts, and fasteners for security
?
Check the ha rness for correct mounting, that all straps are secure, that there are no
twists on any straps
?
Examine prop cage for correct assembly, that it is strong, the netting is tight and on the correct
side
?
Check that nothing can get in the prop. The prop should clear the cage by same distance at all
points.
?
Check the fuel tank and fuel delivery system.
?
Check for correct mounting of prop, and correct torque of prop bolts.
3.0
PREPARING FOR YOUR FIRST
FLIGHT
Fuel and Oil
FLY PRODUCTS recommends the use of a premium unleaded automotive gasoline of 92 octane or
higher, and the use of premium synthetic 2-cycle oil. Mix fresh gas and oil before each flying session.
Store your fuel/oil mixture in an approved, sealed container. Dispose of fuel/oil mixture that is older
than 72 hours.
The recommended fuel/oil ratio is 2%. Be sure to thoroughly agitate the mixture to completely dissolve
the oil.
Use only fresh fuel and oil, and use clean containers, funnels, hoses, etc.
Содержание MAX 100
Страница 1: ...MAX 100 and MAX 130...
