GMI-ROT Series - Absolute Rotary Encoder
User Manual
1. General information
1.1. Introduction
This instruction manual is an integral part of the GMI ROTARY ENCODERS (identified in this
document, with the term encoder) realized by the company FLUX GmbH. For this reason, it
must follow the encoder itself if it is transferred to a new user or owner.
This manual has been drawn to provide operators and technicians involved in the
maintenance of the encoder information and essential instructions to operate properly and
safely.
While showing all the attention and the instructions for the correct use of the encoder by the
operators or to allow maintenance personnel to intervene correctly, this manual assumes
that the use and maintenance personnel has a degree of education that allows them to
interpret the information reported.
1.2 Ownership of the information provided
This instruction manual contains proprietary information.
All rights are reserved.
This manual may not be reproduced or duplicated, in whole or in part, without the prior
written consent of the Manufacturer. The use of this document material is only allowed to the
customer to whom the manual was provided as support of the encoder and only for
purposes of installation, use and maintenance of the encoder the manual refers to.
The manufacturer declares that the information contained in this manual are congruent with
the technical specifications and safety devices of the encoder the manual refers to.
Drawings, diagrams and technical data are updated to the date of publication of this
document and are valid only for the encoder to which they were attached.
The Manufacturer reserves the right to make changes or improvements to this documentary
material without notice.
The Manufacturer assumes no liability for direct or indirect injury to people, things or animals
arising from the use of this document or of the encoder in conditions different than those laid
down.
1.3 Conventions and Definitions
1.3.1 Introduction
The instruction manual of the encoder was divided into chapters that allow, for each major
phase of the life of the encoder (transport, installation, use, setup, maintenance and
disposal), to facilitate the procurement of necessary information to the user of the encoder
itself.
FLUX GmbH - Austria
2022-04, rev00
5/34
